[SLS-CC] (no subject)

[Massimo.Bertinelli at esa.int]

Dear Gian Paolo and Tom,

as anticipated during the meeting in Darmstadt, the C&S WG has finished 
its review of the new draft of the TM Coding Green Book (130.1-G) and you 
can find
attached the final version (of the parts including changes) based on the 
comments received by the deadline set in the meeting minutes.


Beside these changes, we also have an editorial correction suggested by A. 
Modenini (email of 5 March 2019) which I recall here for completeness:

In Fig 6-11, the curves corresponding to CC(7, 2/3) and CC(7, 3/4) are 
apparently inverted: the first one is indeed
expected to have better WER than the second one, having a lower code rate. 
This behaviour is what is indeed observed
in Fig 6-10 (BER).

Considering the positive conclusion of the WG review, on behalf of the WG 
I would like to ask to proceed with the publication of the new version of 
the Book.

Best regards,
Massimo

---------------------------------------------------
Massimo Bertinelli
Communication Systems Engineer
ESA/Estec

Tel. +31 (0)71 5653435
--------------------------------------------------
This message is intended only for the recipient(s) named above. It may contain proprietary information and/or
protected content. Any unauthorised disclosure, use, retention or dissemination is prohibited. If you have received
this e-mail in error, please notify the sender immediately. ESA applies appropriate organisational measures to protect
personal data, in case of data privacy queries, please contact the ESA Data Protection Officer (dpo at esa.int).

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.ccsds.org/pipermail/sls-cc/attachments/20191108/75daaf7b/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: TM SandC Green Doc.doc
Type: application/octet-stream
Size: 959542 bytes
Desc: not available
URL: <http://mailman.ccsds.org/pipermail/sls-cc/attachments/20191108/75daaf7b/attachment-0001.obj>