[Sis-SCPS-INTEREST] checksum errors
Jayasri Sangu
JayasriS at aaesys.com
Fri Jun 30 14:48:34 EDT 2006
Hi All,
Finally I got rid of the checksum errors by swapping the Realtek(RTL8169S) network cards with Intel network cards.
Without scps gateway, Realtek works fine. But with the presence of scps gateway it gives checksum errors.
Thanks
Jayasri
-----Original Message-----
From: sis-scps-interest-bounces at mailman.ccsds.org
[mailto:sis-scps-interest-bounces at mailman.ccsds.org]On Behalf Of Jayasri
Sangu
Sent: Thursday, June 22, 2006 12:01 PM
To: sis-scps-interest at mailman.ccsds.org
Subject: [Sis-SCPS-INTEREST] checksum errors
Hi All,
I have a network setup with 5 machines
A-------- B -------- C ------D --------E
C is a delay machine with the 600ms roundtrip delay.
B & D have the gateway with the following configuration
./configure --gateway=yes --tun=yes --low_idle=yes --low_cpu=yes
The rfile on both B and D is
# GW Resource File - comments are allowed, starting with '#'.
# Comments can be anywhere EXCEPT between parameter values.
# interface A info
AIF_NAME eth1
AIF_RATE 10000000
AIF_BUF 32768
AIF_CC 1
AIF_TCPONLY 1
AIF_MTU 1500
AIF_TUN_NAME tun0
# interface B info
BIF_NAME eth2
BIF_BUF 1000000
BIF_RATE 1000000
BIF_CC 0
BIF_MINRTO 600000
BIF_TUN_NAME tun1
# IPFW info
C_DIVPORT 52000
C_TUN_NAME tun2
I am doing file transfer from E to A.
I can see the TCP checksum errors between D and C on some packets, but I don't see any checksum errors between E and D on the same packets.
Is somethog wrong with my setup??
Is this something to do with the tp_Handler() function , 32bit alignment ???
Thanks
Jayasri
Come see us at CommunicAsia 2006 http://www.communicasia.com/
June 20-23, 2006 in Singapore at the US International Pavilion booth 6F1-03
_______________________________________________
Sis-SCPS-INTEREST mailing list
Sis-SCPS-INTEREST at mailman.ccsds.org
http://mailman.ccsds.org/cgi-bin/mailman/listinfo/sis-scps-interest
More information about the Sis-SCPS-INTEREST
mailing list